LDO Micron Plus Partial Kit

You like the Voron 2.4 but it’s not fitting through your door? How about giving the Micron Plus a try… it’s based on the Voron 2.4 design but shrunk by using 1515 extrusions, smaller steppers. You still get a quite impressive build area of 180x180mm.

The printer is a mod, not an official Voron design, so don’t expect the perfect documentation you are getting from vorondesign developed printers. This is not a good printer for beginners but more on enthusiast level… just to be warned 😉

The LDO Micron Plus Partial Kit contains:

• Steppers
• 1515 Frame
• LDO linear rails
• Build plate assembly (magnet sheet, PEI build sheet, 230VAC heater, bed)
• Motion kit (belts/bearings)
• Acrylic panels panels
• Hardware kit (fasteners, feet etc)

Other essential parts are not included in the kit:

• Hotend
• Extruder parts
• Controller board
• Power supplies
• Wiring harnesses
• Raspberry Pi
• Printed parts
• …

Please refer to the pictures to see, what’s included.

More information, documentation, etc. can be found here