Linneo Stealthburner LED Harness (internal)
The Linneo Stealthburner LED Harness provides you with a ready made harness to connect the three LEDs to the Linneo cable harness (or Linneo Upgrade harness) please order “Molex” version. If you are using the Stealthburner PCB, please order the “JST PH” version. For the Stealthburner 2-piece PCB please use the “Dupont” version
The harness comes with a 3pin Molex Microfit 3.0 connector (Molex version), JST PH connector (JST PH version) or Dupont connector (Dupont version) on one end and three RGBW LEDs (you can can choose between warm, natural and cold white).
It fits perfectly in the Stealthburner cable guides.
Henry (verified owner) –
The LEDs work fine, but the solder joints themselves aren’t terribly strong, probably because the wire is a bit too thin. Whilst installing it, the wires broke a few times, meaning I had to resolder them myself and replace some of them with some 22AWG silicone wire off of eBay. It’s not horrific, but I did have to put extra work in and I was expecting better.
OneTwo3D –
Thanks for the feedback. I’ll discuss that with Linneo. If you want the led harness can also be swapped for a new one.
Aku Kärkkäinen (verified owner) –
The wires we’re a bit long so it took quite a bit bending and some hot glue to get the wires stay in the channels. The biggest complaint is about the connector. I spent almost a day banging my head against a wall trying to figure out why the neopixels won’t light up. I tried three different ports and checked the continuities until I noticed that the din and ground pins were the wrong way around, so I switched them around and that was it. Very frustrating but ultimately easier to fix than if the solderings had been defective.
Kieran Evans (verified owner) –
As stated in other reviews, wires a little long, but otherwise great – saved on fiddling with soldering them myself!